Siemens SX Series Instrucciones de uso - Página 21

Navegue en línea o descargue pdf Instrucciones de uso para Lavavajillas Siemens SX Series. Siemens SX Series 38 páginas. Dishwasher
También para Siemens SX Series: Manual de instrucciones (38 páginas), Manual de instrucciones (42 páginas), Manual de instrucciones (42 páginas), Manual de instrucciones (44 páginas), Manual de instrucciones (46 páginas), Manual de instrucciones (44 páginas), Manual de instrucciones (42 páginas), Manual de instrucciones (48 páginas), Manual de instrucciones (40 páginas), Manual de instrucciones (42 páginas), Manual de instrucciones (44 páginas), Manual de instrucciones (40 páginas)

Imprimir página
Siemens SX Series Instrucciones de uso

End of programme

The programme has ended when
neither of the two displays ` or X
is lit.
The end of the programme is also
indicated by an acoustic signal.
The buzzer volume can be set in 4
stages. Accordingly 0, 1, 2 or 3 displays
are lit (see water hardness table).
Factory setting: 2. This function can be
changed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down button > P and press
START button h until the dry
display ` and salt refill
indicator )* flash.
4. Release buttons.
5. Keep pressing button > P until
the salt refill indicator )* and rinse
aid refill indicator )" flash.
6. Release buttons.
The refill indicators )* and )"
flash and the displays # and +
are lit (= Setting 2). The set buzzer
volume can be heard.
To change the setting:
1. Press the button < H until
the required setting has been
selected.
2. Press START button h.
The displays go out. The selected
setting is saved.
3. Close the door.
Note
To save energy, the dishwasher
automatically switches off after the end
of the programme.
Operating the appliance

Interrupting the programme

1. Open the door.
2. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
3. To continue the programme, switch
on the ON/OFF switch ( again.
4. Close the door.
T erminating the programme
Te r m i n a t i n g t h e p r o g r a m m e
(Reset)
1. Open the door.
2. Press START button h for
approx. 3 sec. until all displays go
out.
3. Close the door.
The remaining programme sequence
for draining the residual water takes
approx. 1 minute.

Changing the programme

When the START button h has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme
(Reset).
en
21