Siemens EC7A5RB90A Instrucciones de uso - Página 8

Navegue en línea o descargue pdf Instrucciones de uso para Placa Siemens EC7A5RB90A. Siemens EC7A5RB90A 20 páginas.

Imprimir página

Installation and connection

Before Leaving

Check all connections for gas leaks with soap and

water. DO NOT use a naked flame for detecting leaks.

Ignite all burners both individually and concurrently to

ensure correct operation of gas valves, burners and

ignition. Turn gas taps to low flame position and

observe stability of the flame for each burner

individually and all together. Adhere the duplicate data

plate to an accessible location near the hotplate. When

satisfied with the hotplate, please instruct the user on

the correct method of operation. In case the appliance

fails to operate correctly after all checks have been

carried out, refer to the authorised service provider in

your area.

It should be expressly noted that we cannot accept any

liability for direct or indirect damage caused by wrong

connection, leakage or improper installation. When

being repaired, the appliance must always be

disconnected from the mains supply; if required, notify

our customer service.

Converting the cooktop from Nat. Gas to

Universal LPG

All work involved in installation, setting and adaptation

to a different gas type must be carried out by a licensed

gas fitter and must comply with current regulations and

the conditions laid down by the local gas company.

Before conversion the cooktop must be disconnected

from the electricity and gas valves must be turned to the

OFF position.

Important: After finishing, stick the sticker, indicating

the new gas type, close to the specifications plate.

Replacing the injectors

Request change-over injectors from our customer

service deparment (refer injector chart below for sizes).

Natural Gas

Hourly Gas

Consumption

(MJ)

Economy

burner

Standard-

6.85

output

burner

High-output

burner

Wok burner

4 kW

Dual wok

19.5

burner

5 kW

Universal LPG

Injector

Hourly Gas

mark

Consumption

(MJ)

3.5

116

153

181

190

16.5

Remove all pan supports, burner caps and

distributors.

To replace the injectors, use the key that is available

from our technical service with code 340847 (for

double-flame burners 340808). See table. It is

important to make sure that the injector does not

become detached during removal or fastening. They

must be properly tightened to ensure that there are

no leaks.

With these burners, there is no need to adjust the

primary air.

Fasten the distributors and burner caps to the

corresponding burners. In addition to this, put the

pan supports in place on the corresponding burners.

Injector

mark