Digital Matter G62 Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para GPS Digital Matter G62. Digital Matter G62 15 páginas.
También para Digital Matter G62: Manual de introducción (3 páginas)

Imprimir página

Digital Matter

Insert the battery

The battery should be provided disconnected inside the housing. The battery plug is a three-

way connector on the top side of the PCB.

1. Insert the battery plug into the connector. It should only be possible in one orientation.

2. The LED on the board will light up and flash if the battery has sufficient charge.

Batteries are supplied fully charged.

3. Route the battery wires into the space between the GPS board and the housing. Take

care to avoid trapping the wires when sealing the device.

Check the device has connected

4.3.1. LED Behaviour

The battery should come pre-charged. Once you insert it, the internal LED will come on and

flash.

The LED will flash slowly at first. When it opens a connection to the server, it will flash fast.

Once data is sent, it will go solid briefly, and revert to flashing fast. When the device goes to

sleep, the LED will switch off.

If the battery is too low, use the harness to provide external power.

If the LED flashes but the G62 does not connect, check the SIM is in the holder correctly and

check that the SIM is working. Further troubleshooting steps are discussed further on in this

document.

4.3.2. OEM Installer Page

The OEM Installer page is designed to verify than an installation has been done correctly. We

will be using it going forward in this document.

It is not password protected, and as such is designed to not give any sensitive information

away.

To access the page, go to

G62 Installation Guide

www.oemserver.com/installer

All information provided in this document is subject to legal disclaimers

Revision 1.0 - 20 September 2018

G62 Install Guide

Page 5 of 15