Ricoh SR770 Manual de instalación

Navegue en línea o descargue pdf Manual de instalación para Impresora todo en uno Ricoh SR770. Ricoh SR770 4 páginas. Punch kit type for machine code: g060; g080; g082; g106

Imprimir página

SR770

For Machine Code:

G060 / G080/ G082/ G106

INSTALLATION GUIDE

Important

❒ Check the printer nameplate to confirm the model code.

❒ Install the paper feed unit before installing the 2 tray finisher.

❒ Install the memory unit options before attaching the 2 tray finisher.

❒ You cannot install the 2 tray finisher unless both the paper feed unit and duplex unit with options are installed.

❒ The 2 tray finisher requires the optional printer hard disk or optional memory unit of total 128 MB.

❒ You cannot install the 4-bin mailbox and 2 tray finisher at the same time.

Note

❒ The 2 tray finisher weighs approximately 53kg (116.9 lbs).

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

Check the contents of the box:

Description

Finisher

Short Screws

Long Screws

Connecting Bracket

Mounting Bracket

Rail

2 Tray Finisher Trays

Installation Guide(This sheet)

Be sure to check the following points:

•The power is turned off.

•The power cord is unplugged from the wall outlet.

•The interface cable is unplugged from the printer.

Remove the adhesive tape and packing materials.

Note

❒ Do not remove the adhesive tape holding the cable yet. Remove

it in step

Front and Side

Back

Caution

• Before installing options, the machine should be turned off and unplugged for at

least thirty minutes. Components inside the machine become very hot, and could

result in a burn if touched.

• When lifting the machine, use the grips on both sides. The machine could break

(Code: G565)

or cause injury if dropped.

• It is dangerous to handle the plug with wet hands. Doing this may result in receiving

an electric shock.

• Before moving the machine, unplug the power cord from the outlet. If the cord is

unplugged abruptly, it could become damaged. Damaged plugs or cords can

cause an electrical or fire hazard.

• When moving the 2 tray finisher, hold the center of both sides, and lift slowly.

Lifting carelessly or dropping it may cause injury.

Q'ty

Interior

Slowly open the front cover by pulling on the two areas on

the left and right.

Remove the green screwdriver, and then close the front

cover.

Use this screwdriver for all attachment and detachment of screws.

Note

❒ After using the screwdriver, return it to its original position on

the inside of the front cover.

ZHXH171J

G565-8600C