Epson ELPMB64 Manual de instalación - Página 4
Navegue en línea o descargue pdf Manual de instalación para Proyector Epson ELPMB64. Epson ELPMB64 32 páginas. Short throw projector wall mount
Imprimir página
Introduction
Handle the power cord carefully to avoid fire or electric shock.
Incorrect handling could cause fire or electric shock. Observe the following precautions when
handling:
•
Do not handle the power plug with wet hands.
•
Do not use a power cord that is damaged or modified.
•
Do not pull the power cord with too much force when routing the cable through the setting plate.
Do not install the product in a location where it might be exposed to vibration or shock,
which could cause damage to the projector or mounting surface.
This could cause damage to the projector or mounting surface. If this product falls, it could cause
death or personal injury.
When installing on a wall, install so that it can sufficiently support the mass of the projector
and the Wall mount and resist any horizontal vibration. Use M8 nuts, bolts and so on.
Nuts and bolts smaller than M8 could cause the mount to fall. Epson accepts no responsibility for
any damage or injury caused by lack of wall strength or inadequate installation.
The installation work should be performed by at least two qualified service personnel. If
you need to loosen any screws while installing, be careful not to drop the mount.
If this product falls, it could cause death or personal injury.
When installing this product on a wall, the wall requires enough strength to hold the pro-
jector and the Wall mount.
This wall mount should be installed on a concrete wall.
Before installing this product on a wall, check the total mass of the projector and wall mount to
ensure that the wall is strong enough to support the weight. If the wall is not strong enough,
reinforce the wall before installation.
Inspect the setting plate on a regular basis to ensure there are no broken parts or loose
screws.
If any parts are damaged, stop using the setting plate immediately. If this product falls, it could
cause death or personal injury.
Do not disassemble or remodel this product.
There are numerous high-voltage sections inside the product that could cause a fire, electric shock,
or an accident.
Do not hang on the mount or hang a heavy object on it. Or do not hang a heavy object on
the mount.
If this product falls, it could cause death or personal injury.
Do not use adhesives, lubricants, or oils to install or adjust the Wall mount.
If you use adhesives to prevent the screws from loosening or things such as lubricants or oils on
the slide plate fixing part of the projector, the case may crack and cause the projector to fall,
resulting in personal injury or property damage.
Tighten all screws firmly after adjustment.
Otherwise, the projector or wall mount may fall and cause personal injury or property damage.
Never loosen the bolts and nuts after installation.
Confirm on a regular basis that the screws have not become loose. If you find any loose screws,
tighten them firmly. Otherwise, the projector or wall mount may fall and cause personal injury or
property damage.
Warning
2