Epson EMP 30 - PowerLite 50c XGA LCD Projector Información sobre el producto - Página 6
Navegue en línea o descargue pdf Información sobre el producto para Proyector Epson EMP 30 - PowerLite 50c XGA LCD Projector. Epson EMP 30 - PowerLite 50c XGA LCD Projector 13 páginas. Epson powerlite 70c: quick start
También para Epson EMP 30 - PowerLite 50c XGA LCD Projector: Especificaciones (2 páginas), Configuración rápida (2 páginas)
Imprimir página
EPSON Powerlite 50c/70c
Depending on your computer's video card, you might need
to use the Display utility in the Control Panel to make sure
that both the LCD screen and external monitor port are
enabled. See your computer's documentation or online help
for details.
Check your computer's video resolution and scan frequency
to see if they are supported, as listed on page 3. You may
need to adjust your computer's resolution and scan
frequency to match one of the modes listed.
Focusing Your Image
Rotate the focus ring to sharpen the image.
Note:
If the image from your computer is still out of focus, you can
increase the clarity by pressing the Auto button on the remote
control. This optimizes the projector's tracking, sync, and position
settings. (You can also adjust these settings using the projector
menus.)
Adjusting the Image Size
You can adjust your image size using the
the projector or zoom into a portion of the image using the
button on the remote control.
E-Zoom
Using the Wide/Tele Button
To enlarge or reduce your image size in small increments, use
the
button on the projector. Press the
Wide/Tele
button to reduce the image size, or the
button to enlarge the image to full size.
Tele
Wide/Tele button
Note:
You can always move the projector closer to or farther from the
screen to adjust the image size.
6 - EPSON Powerlite 50c/70c
focus
ring
button on
Wide/Tele
side of the
T
side of the
W
Wide/
Enlarge
W
T
Reduce
W
T
01/01
Using the E-Zoom Button
If you want to zoom in on a portion of the image, use the
and
buttons on the remote control. Press the
E-Zoom
Enter
side of the
button to zoom into your image in small
+
E-Zoom
increments. Press the
side to zoom out.
–
To position the zoomed image on the screen, press the top,
bottom, left, or right side of the
control. (Press
to return your image to its original size and
Esc
turn off E-Zoom.)
E-Zoom button
+
Zoom in
–
Zoom out
Adjusting the Image Height
If your image is too low, you can raise it by extending the
projector's feet.
1. Stand behind the projector. Pull up the blue foot release
levers and lift the front of the projector. This unlocks the
feet.
2. Raise or lower the front of the projector as necessary.
Caution
To avoid damaging the lens, do not lift the projector by the lens.
3. Once the image is positioned where you want it, release the
levers to lock the feet into position.
4. To fine-tune the height,
rotate the feet clockwise to
raise the projector and
counterclockwise to lower it.
button on the remote
Enter
top
Enter button
left
bottom
right