Cisco 10005 Manual de instalación - Página 13
Navegue en línea o descargue pdf Manual de instalación para Enrutador de red Cisco 10005. Cisco 10005 20 páginas. Cisco systems power supply installation guide
Imprimir páginaTroubleshooting the Installation
FCC Class B Compliance
78-12652-01
Table 1
contains troubleshooting tips for an AC-powered Cisco 10005 ESR.
Table 1
Troubleshooting AC-Powered Systems
Symptom
System fails to power
on
Power supply Fault
LED is on (yellow)
The equipment described in this manual generates and might radiate
radio-frequency energy. If it is not installed in accordance with Cisco installation
instructions, it might cause interference with radio and television reception. This
equipment has been tested and found to comply with the limits for a Class B
digital device in accordance with the specifications in part 15 of the FCC rules.
These specifications are designed to provide reasonable protection against such
interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation.
Modifying the equipment without written authorization from Cisco might result
in the equipment no longer complying with FCC requirements for Class A or
Class B digital devices. In that event, your right to use the equipment might be
limited by FCC regulations, and you might be required to correct any interference
to radio or television communications at your own expense.
Steps to Take
Check that:
All power cords are properly connected to the
•
Cisco 10005 and at the power connection end.
The power switches are in the | (On) position.
•
The Power LED is on (green).
•
The fan assembly is fully inserted (Fan Status
•
LED is green).
Make sure the power switch on the power module
•
is set to | (On).
For more troubleshooting information, see the
•
Cisco 10000 Series ESR Troubleshooting Guide.
Cisco 10005 ESR AC Power Supply Installation
FCC Class B Compliance
13