Cisco 12016 Manual de instrucciones de sustitución - Página 8

Navegue en línea o descargue pdf Manual de instrucciones de sustitución para Enrutador de red Cisco 12016. Cisco 12016 32 páginas. Blower module and air filter for cisco 12016, cisco 12416, and cisco 12816 router
También para Cisco 12016: Instrucciones de desembalaje Manual (28 páginas), Ficha de datos (9 páginas), Manual de instrucciones (16 páginas), Manual de instrucciones de sustitución (18 páginas)

Removing and Installing the Chassis

Procedures for removing and installing the chassis are described in the following sections:

•

Unpacking the Replacement Chassis

The process of unpacking the replacement chassis consists of opening and disassembling the shipping

package to expose the chassis on the shipping pallet, then removing the chassis and scissor-jack platform

from the shipping pallet. See the

procedures.

When the replacement chassis and scissor-jack platform have been placed near the rack site, temporarily

connect the central office grounding system or interior equipment grounding system to the supplemental

bonding and grounding receptacles on the router. There are two receptacles on the front flanges of the

chassis, near the lower corners of the switch fabric card cage. (See

receptacles on the top of the power interface panel on the back of the chassis. (See

bonding and grounding receptacle consists of a round bolt hole and an elongated bolt hole, surrounded

by an area of bare metal.

For more information on the bonding and grounding cable and connector requirements, refer to the

"Supplemental Unit Bonding and Grounding Guidelines" section in the Cisco 12016, Cisco 12416, and

Cisco 12816 Router Installation and Configuration Guide.

Cisco 12016, Cisco 12416, and Cisco 12816 Router Chassis Replacement Instructions

"Unpacking the Replacement Chassis" section on page 8

for detailed

Figure

3.) There are also two

Figure

4.) Each

78-16082-01