Cisco 1700 series Solución de problemas de hardware - Página 5

Navegue en línea o descargue pdf Solución de problemas de hardware para Enrutador de red Cisco 1700 series. Cisco 1700 series 12 páginas. Secure firewall management center
También para Cisco 1700 series: Manual de cumplimiento de la normativa e información de seguridad (45 páginas), Manual (15 páginas), Manual de configuración (25 páginas), Nota de aplicación (41 páginas), Manual general (13 páginas), Configuración de (34 páginas), Manual (5 páginas), Manual de inicio rápido (6 páginas), Manual de instalación del hardware (46 páginas)

Imprimir página
Cisco 1700 series Solución de problemas de hardware
Cisco - Hardware Troubleshooting for Cisco 1700 Series Routers
If you have the output of a show command from your Cisco device (including show technical-
support), you can use the
fixes. To use the
Output Interpreter
enabled.
Troubleshooting ISDN Interfaces
Here is a list of references to use for troubleshooting ISDN interfaces:
Troubleshooting ISDN Layer 1
Troubleshooting ISDN Layer 2
Troubleshooting ISDN Layer 3
Troubleshooting Router Hangs
Refer to
Troubleshooting Router Hangs
Troubleshooting Bus Error Crashes
The system encounters a bus error when the processor tries to access a memory location that either does
not exist (a software error) or does not respond properly (a hardware problem). A bus error can be
identified by looking at the output of the show version command provided by the router (if not power-
cycled or manually reloaded).
Here are two examples of bus error crashes:
Router uptime is 2 days, 21 hours, 30 minutes
System restarted by bus error at PC 0x30EE546, address 0xBB4C4
System image file is "flash:igs-j-l.111-24.bin", booted via flash
.........
At the console prompt, the following error message might also be seen during a bus error:
*** System received a Bus Error exception ***
signal= 0xa, code= 0x8, context= 0x608c3a50
PC = 0x60368518, Cause = 0x20, Status Reg = 0x34008002
For more information regarding this issue, refer to
Router Does Not Boot
Capturing information from the console of the router is essential for troubleshooting a router that does
not boot. The console output should be logged in a file for later analysis or for the Cisco Technical
Assistance Center (TAC) if a TAC case is opened.
The following table lists symptoms and recommended actions to take if you are encountering boot
problems:
http://kbase:8000/paws/servlet/ViewFile/17959/hwts_1700_17959.xml?convertPaths=1
Output Interpreter
(
registered
(
registered
customers only
for this issue.
) to display potential issues and
customers only
) , you must be logged in and have JavaScript
Troubleshooting Bus Error
Page 5 of 12
Crashes.
01/10/2004