Cisco 2524 - Router - EN Manual de configuración - Página 15

Navegue en línea o descargue pdf Manual de configuración para Enrutador de red Cisco 2524 - Router - EN. Cisco 2524 - Router - EN 23 páginas. Troubleshooting guide
También para Cisco 2524 - Router - EN: Manual de configuración (23 páginas), Visión general (10 páginas), Preparación de la instalación (19 páginas), Manual de solución de problemas (4 páginas)

Enter the BRI interface, encapsulation method (PPP), authentication type, target

Step 4

router's IP address and ISDN number to dial, and the dialer group number:

Router (config)# interface bri port_number

Router (config-if)# encapsulation ppp

Router (config-if)# ppp authentication chap

Router (config-if)# dialer map ip targetrouter_ipaddress

targetrouter_phonenumber

Router (config-if)# dialer-group groupnumber

Do not use periods or hyphens when you enter dialing numbers.

Note

Step 5

Some ISDN switch types, such as Basic NI1 or DMS-100 switch service, require

you to conﬁgure a service proﬁle identiﬁer (SPID). Enter the SPID information as

follows, substituting the appropriate entries for your installation:

Router (config-if)# isdn spid1 SPID_no phone_number

Router (config-if)# isdn spid2 SPID_no phone_number

Step 6

To set up a second B channel for bandwidth on demand, enter the load-threshold

command to set the ISDN load threshold. The load threshold determines the

percentage of network loading at which the second ISDN B channel is triggered.

The value ranges from 1 to 255 (100 percent).

Router (config-if)# dialer load-threshold 128

In this example, the value of 128 means that when the ﬁrst B channel reaches

50 percent of its bandwidth capacity (128 equals 50 percent of 255), the second B

channel will be activated to assist with the bandwidth load.

Enter the access-list command to conﬁgure the ISDN line to come up whenever

Step 7

IP packets are to be sent:

Router (config-if)# access-list access-list-number permit ip

sourcerouter-ipnetwork sourcerouter-subnetmask

targetrouter-ipnetwork targetrouter-subnetmask

Router (config)# dialer-list groupnumber list access-list-number

Configuring the Cisco 2524 and Cisco 2525 Routers 4-15

Configuring the Router