Cisco 2525 Manual de configuración - Página 3

Navegue en línea o descargue pdf Manual de configuración para Enrutador de red Cisco 2525. Cisco 2525 23 páginas. Troubleshooting guide
También para Cisco 2525: Manual de configuración (23 páginas), Visión general (10 páginas), Preparación de la instalación (19 páginas), Manual de solución de problemas (4 páginas)

Using Configuration Mode

You can configure the router manually if you prefer not to use AutoInstall or the System

Configuration Dialog. Take the following steps to configure the router manually:

Step 1

Step 2

Step 3

Step 4

Step 5

To see the current operating configuration, enter the show running-config command at the

enable prompt:

Router# show running-config

To see the configuration in NVRAM, enter the show startup-config command at the enable

prompt:

Router# show startup-config

Connect a console terminal following the instructions in the section "Connecting

the Console Terminal and Modem" in the chapter "Installing the Cisco 2524 and

Cisco 2525 Routers," and then power ON the router.

When you are prompted to enter the initial dialog, enter no to go into the normal

operating mode of the router:

Would you like to enter the initial dialog? [yes]: no

After a few seconds you will see the user EXEC prompt (Router>). Enter the

enable command to enter enable mode. You can only make configuration changes

in enable mode.

Router> enable

The prompt changes to the privileged EXEC (enable) prompt:

Router#

Enter the configure terminal command at the enable prompt to enter

configuration mode:

Router# configure terminal

You can now enter any changes you want to the configuration.

Press Ctrl-Z to exit configuration mode.

Configuring the Cisco 2524 and Cisco 2525 Routers 4-3

Configuring the Router