Cisco 2600 Series Configuración - Página 13

Navegue en línea o descargue pdf Configuración para Enrutador de red Cisco 2600 Series. Cisco 2600 Series 15 páginas. Configuring adsl wic to support pppoe clients
También para Cisco 2600 Series: Manual de instalación (12 páginas), Notas de publicación (32 páginas), Nota de aplicación (41 páginas), Ficha de datos (6 páginas), Anexo (15 páginas), Manual de instalación (22 páginas), Visión general (13 páginas), Manual de inicio rápido (2 páginas), Manual (5 páginas)

2.3 RIP and OSPF Redistribution

If you like to redistribute routing information to OSPF, you have to tell RIP running

router process-id of OSPF and default-metric value. For example

Router(config-router)#redistribute ospf process-id

And default-metric value:

Router(config-router)#default-metric value

Value is a positive integer.

In OSPF you have to mention any default-metric value, just give the next command, if

you like to transform routing information to RIP.

Router(config-router)#redistribute rip

In addition in classless addressing, you have to write subnets, like

Router(config-router)#redistribute rip subnets

When you have a network with running a routing protocol and you like to connect it to

another network running B routing protocol throughout one or more routers, you have

to tell about border area router or gateway router with the following command. B

network is generally much bigger and for example the Internet.

Router(config-router)#default-information originate

If a LAN is connected to a router as shown in Fig. 3., you have to tell about it to the

router's routing protocol. Just write

Router(config-router)#redistribute connected

Figure 3. Redistributing to LAN

LAN