Cisco 2600 Series Configuración - Página 9

Navegue en línea o descargue pdf Configuración para Enrutador de red Cisco 2600 Series. Cisco 2600 Series 15 páginas. Configuring adsl wic to support pppoe clients
También para Cisco 2600 Series: Manual de instalación (12 páginas), Notas de publicación (32 páginas), Nota de aplicación (41 páginas), Ficha de datos (6 páginas), Anexo (15 páginas), Manual de instalación (22 páginas), Visión general (13 páginas), Manual de inicio rápido (2 páginas), Manual (5 páginas)

Table 2. RIP version commands in sending.

Command

ip rip send version 1

ip rip send version 2

ip rip send version 1 2

To control how packets received from an interface are processed, use one of commands

shown in Table (3).

Table 3. RIP version commands in receiving.

Command

ip rip receive version 1

ip rip receive version 2

ip rip receive version 1 2

2.1.3 No Form

To turn off any feature of RIP routing, for example to turn off neighbor 10.12.0.5

255.255.255.252, give the next command:

Router(config-router)#no neighbor 10.12.0.5 255.255.255.252

To turn off RIP, use the no router rip command:

Router(config)#no router rip

You can modify OSPF routing by giving the next command in global configuration

mode:

Router(config)#router ospf process-id

Process-id is a number between 1 and 65535. Pick the process-id which is not being

used. To determine which ids are being used, issue the show process command

Router#show ip ospf

Then in router configuration mode

next listed commands:

Purpose

Configure an interface to send only RIP

version 1 packets.

Configure an interface to send only RIP

version 2 packets.

Configure an interface to send RIP

version 1 and 2 packets.

Purpose

Configure an interface to receive only

RIP version 1 packets.

Configure an interface to receive only

RIP version 2 packets.

Configure an interface to receive RIP

version 1 and 2 packets.

Router(config-router)#

you can give the