Cisco 2612 Manual de inicio rápido - Página 20

Navegue en línea o descargue pdf Manual de inicio rápido para Enrutador de red Cisco 2612. Cisco 2612 29 páginas. Including license and warranty
También para Cisco 2612: Manual de inicio rápido (29 páginas)

Imprimir página

Initial Configuration Using Cisco Router and Security Device Manager

If the following messages appear at the end of the startup sequence, Cisco Router and Security Device Manager (SDM) is

installed on your router:

yourname con0 is now available

Press RETURN to get started.

For instructions on configuring your router by using SDM, refer to the Cisco Router and Security Device Manager (SDM) Quick

Start Guide.

If the messages above do not appear, SDM and the Cisco Router and Security Device Manager (SDM) Quick Start

Tip

Guide were not shipped with your router. If you want to use SDM, you can download the latest version of SDM and

instructions for installing it on your router from the following location:

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

To obtain the SDM quick start guide, SDM release notes, and other SDM documentation, go to www.cisco.com/go/sdm

and click the Technical Documentation link.

Initial Configuration Using the Setup Command Facility

This section shows how to use the setup command facility to configure a host name for the router, set passwords, and configure

an interface for communication with the management network. If you see the following messages at the end of the startup

sequence, the setup command facility has been invoked automatically:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

The setup command facility prompts you for basic information about your router and network, and it creates an initial

configuration file.The prompts vary, depending on your router model, the installed interface modules, and the software image.

The following example and the user entries (in

For a description of interface numbering, see the "Interface Numbering" section on page 23.

Note

If you make a mistake while using the setup command facility, you can exit and run the setup command facility again.

Press Ctrl-C, and enter setup at the privileged EXEC mode prompt (

Step 1

To proceed using the setup command facility, enter yes.

Would you like to enter the initial configuration dialog? [yes/no]: yes

Step 2

When the following messages appear, press Return to enter basic management setup:

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity

for management of the system, extended setup will ask you

to configure each interface on the system

Would you like to enter basic management setup? [yes/no]: yes

) are shown as examples only.

bold

2600#