Cisco 3600 Series Nota de configuración - Página 2

Navegue en línea o descargue pdf Nota de configuración para Enrutador de red Cisco 3600 Series. Cisco 3600 Series 25 páginas. Memory upgrade
También para Cisco 3600 Series: Productos (10 páginas), Instrucciones de actualización (30 páginas), Manual del usuario (17 páginas), Nota de aplicación (41 páginas), Manual de configuración (36 páginas), Manual del usuario (25 páginas), Anexo (15 páginas), Manual del usuario (7 páginas), Manual (5 páginas), Nota de configuración (23 páginas), Nota de configuración (18 páginas)

•

Warning

equipment. (To see translated versions of this warning, refer to the Regulatory Compliance and

Safety Information document that accompanied the router.)

Warning

AC units; disconnect the power at the circuit breaker on DC units. (To see translated versions of this

warning, refer to the Regulatory Compliance and Safety Information document that accompanied the

router.)

Warning

power cord. (To see translated versions of this warning, refer to the Regulatory Compliance and

Safety Information document that accompanied the router.)

The following warning applies to routers with a DC power supply:

Warning

the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that

services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of

the circuit breaker in the OFF position. (To see translated versions of this warning, refer to the

Regulatory Compliance and Safety Information document that accompanied the router.)

Caution

have discharged all static electricity from your body before opening the chassis. Before performing

procedures described in this document, review the next section, "Safety Recommendations."

Note

the front.

2 Cisco 3600 Series Memory Upgrade Conﬁguration Note

Upgrading Flash Memory, page 14

Upgrading the ROM, page 18

Replacing the Cover, page 21

Replacing Connections to the Router, page 22

Obtaining Service and Support, page 23

Cisco Connection Online, page 23

Only trained and qualiﬁed personnel should be allowed to install or replace this

Before working on a chassis or working near power supplies, unplug the power cord on

Before working on a system that has an on/off switch, turn OFF the power and unplug the

Before performing any of the following procedures, ensure that power is removed from

To avoid damaging electrostatic discharge (ESD)-sensitive components, ensure that you

When a procedure refers to the left side or right side of the chassis, it means as viewed from