Cisco 3600 Series Nota de configuración - Página 22

Navegue en línea o descargue pdf Nota de configuración para Enrutador de red Cisco 3600 Series. Cisco 3600 Series 25 páginas. Memory upgrade
También para Cisco 3600 Series: Productos (10 páginas), Instrucciones de actualización (30 páginas), Manual del usuario (17 páginas), Nota de aplicación (41 páginas), Manual de configuración (36 páginas), Manual del usuario (25 páginas), Anexo (15 páginas), Manual del usuario (7 páginas), Manual (5 páginas), Nota de configuración (23 páginas), Nota de configuración (18 páginas)

Replacing Connections to the Router

Figure 17

Replacing Connections to the Router

Follow these steps to make ﬁnal connections to the router:

Warning

see translated versions of this warning, refer to the Regulatory Compliance and Safety Information

document that accompanied the router.)

Step 1

Step 2

Step 3

Step 4

22 Cisco 3600 Series Memory Upgrade Conﬁguration Note

Replacing the Cisco 3640 Cover

Read the installation instructions before you connect the system to its power source. (To

Replace all network connections.

If you have an AC-powered router, plug the power cord into a 3-terminal, single-phase

power source that provides power within the acceptable range (100 to 240 VAC, 50 to

60 Hz).

If you have a DC-powered router, remove the tape from the circuit breaker switch handle

and reinstate power by moving the handle of the circuit breaker to the ON position.

Turn ON the power switch. The power LED on the front panel of the router should go

ON.)

Check the OK LED on the right side of the front panel to verify that it goes ON after a

few seconds delay when booting. If you have problems, see the next section, "Obtaining

Service and Support."