Cisco 3700 series Instalación y formato - Página 15

Navegue en línea o descargue pdf Instalación y formato para Enrutador de red Cisco 3700 series. Cisco 3700 series 34 páginas. Siemens hipath 4000 release 1 and siemens hicom 330e release 3.1 to cisco ios voice gateway using e1 qsig with h.323
También para Cisco 3700 series: Instrucciones de actualización (30 páginas), Ficha de datos (8 páginas), Nota de aplicación (41 páginas), Manual de instalación (12 páginas)

Imprimir página

March 2002

Figure 13

Tighten the two captive retention screws; there is one at each edge of the CPU/mainboard.

Step 3

Hold the front panel straight out from the chassis, engage the hinges, and close the front panel. (See

Step 4

Figure

Tighten the two captive screws behind the small access panel at the right-hand edge.

Step 5

Power ON the router.

Step 6

Observe the following precaution if your router uses DC power:

Warning

After wiring the DC power supply, remove the tape from the circuit breaker switch handle and

reinstate power by moving the handle of the circuit breaker to the ON position. To see translations

of the various warnings that appear in this publication, refer to the Regulatory Compliance and

Safety Information document that accompanied this device.

78-13892-03

Inserting Plug-in CPU/Mainboard into a Cisco 3745 Chassis

Captive

retention

screw

14.)

Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards

Internal CompactFlash Memory Card Installation and Removal

Ejector levers

Captive

retention

screw