Cisco NCS 4200 Series Manuales de configuración - Página 3
Navegue en línea o descargue pdf Manuales de configuración para Enrutador de red Cisco NCS 4200 Series. Cisco NCS 4200 Series 30 páginas. 1 port oc-48/ 4 port oc-12/oc-3 + 12 port t1/e1 + 4 port t3/e3 cem interface module configuration guide, cisco ios xe fuji 16.7.x (cisco ncs 4200 series)
También para Cisco NCS 4200 Series: Manual de configuración (36 páginas)
Imprimir página
• Both OCx and PDH are supported on Cisco NCS 4201 and NCS 4202 Routers.
Benefits of VCoP Smart SFP
• Supports channelization upto STS1 channel
• Reduces network complexity
Prerequisites
• The Multi-Protocol Label Switching (MPLS) and Interior Gateway Protocol (IGP) endpoints are up and running fine between
the PE nodes.
• Ensure that SyncE is configured.
• Use the PTP Telecom profile, G.8265.1 for frequency synchronization, for CEM.
• VCoP smart SFP on OCn mode supports single-mode optical fiber cables.
• Port interface is set as default by using the default int Gig 0/0/8 command before inserting VCoP smart SFP on GE or 10GE
port.
• The GE or 10GE port interface is brought up using the no shutdown command.
• In cases where a non-VCoP SFP is to be inserted on any port from which any VCoP smart SFP is removed, then before inserting
non-VCoP SFP, the VCoP smart SFP configuration is removed using the below commands:
◦ For OC-3
no platform smart-sfp interface Gig x/y/z type oc-3
◦ For OC-12
no platform smart-sfp interface Gig x/y/z type oc-12
◦ For T3
no platform smart-sfp interface Gig x/y/z type ds3
• Replace GE with 10GE in the above commands to configure VCoP as 10GE port
Note
interface when inserted in a 10GE port.
• There is no need to remove platform smart-sfp interface Gig/TenGig x/y/z type
oc-3/oc-12/ds3 command if you are replacing one VCoP smart SFP with the same
or another VCoP smart SFP.
• To connect the CE nodes, VCoP smart SFP uses single mode fiber (SMF) over the LC optical interface for OCx mode and DIN
1.0/2.3 Coaxial connector cable for T3 mode.
3