Cisco NCS 4200 Series Manual de configuración - Página 19
Navegue en línea o descargue pdf Manual de configuración para Enrutador de red Cisco NCS 4200 Series. Cisco NCS 4200 Series 36 páginas. 1 port oc-48/ 4 port oc-12/oc-3 + 12 port t1/e1 + 4 port t3/e3 cem interface module configuration guide, cisco ios xe fuji 16.7.x (cisco ncs 4200 series)
También para Cisco NCS 4200 Series: Manuales de configuración (30 páginas)
Imprimir página
Configuring SDH
Restrictions for Scale PW Circuits
• Only 1000 CEM PW Circuits per OCN Interface modules are supported.
Configuring Mediatype Controller
Each SFP port (16-19) can be configured as STM-1, STM-4, STM-16.
You must select the MediaType controller to configure and enter the controller configuration mode.
You must configure the controller as a SDH port.
To configure MediaType Controller:
enable
configure terminal
controller MediaType 0/0/16
mode sdh
end
Configuring Rate on SDH Ports
To configure rate on SDH ports:
enable
configure terminal
controller MediaType 0/0/16
mode sdh
controller sdh 0/0/16
rate [stm1 | stm4 | stm16]
end
The configuration of no form of the command is not suported. To restore to the default condition, use no
Note
mode sdh command under Mediatype controller after removing all configuration under that port. .
SDH Line and Section Configuration Parameters
The following parameters affect SDH configuration at the line and section levels.
Overhead
Sets the SDH overhead bytes in the frame header to a specific standards requirement, or to ensure
interoperability with equipment from another vendors.
• J0 — Sets the J0 or C1 byte value in the SDH section overhead.
• S1S0 — Sets the SS bits value of the H1 byte in the SDH line overhead.
The supported values of J0 are 1 byte, 16 bytes, and 64 bytes.
Note
1 port OC-48/ 4 port OC-12/OC-3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
Configuring Mediatype Controller
IOS XE Fuji 16.7.x (Cisco NCS 4200 Series)
19