Configuration Example
Step 10
Step 11
Step 12
Step 13
Configuration Example
The following example shows how to configure an IP network that supports 3G HD video broadcast traffic:
switch# configure terminal
switch(config)# hardware access-list tcam region ing-ifacl 2048
switch(config)# feature nbm
switch(config)# ip multicast multipath nbm
switch(config)# nbm flow bandwidth 3000
Setting NBM Per Flow Bandwidth as 3000.
Existing NBM Per Flow Bandwidth Value (1000) will continue to be used.
Changes shall take effect after reload
switch(config)# feature ptp
switch(config)# ptp source 10.10.10.1
switch(config)# interface ethernet 1/1
switch(config-if)# ptp
switch(config-if)# ptp announce interval smpte-2059 1
switch(config-if)# ptp announce timeout smpte-2059 5
switch(config-if)# ptp delay-request minimum interval smpte-2059 -1
switch(config-if)# ptp sync interval smpte-2059 -1
switch(config-if)# ptp vlan 1
Related Documentation
Related Topic
IP fabric for media
Cisco Nexus 9000 Series NX-OS IP Fabric for Media Solution Guide, Release 7.0(3)I4(2)
18
Command or Action
[no] ptp vlan vlan-id
Example:
switch(config-if)# ptp vlan 1
show ptp brief
Example:
switch(config-if)# show ptp brief
show ptp port interface interface
slot/port
Example:
switch(config-if)# show ptp port
interface ethernet 2/1
copy running-config startup-config
Example:
switch(config-if)# copy
running-config startup-config
Purpose
(Optional)
Specifies the VLAN for the interface where PTP is
being enabled. You can enable PTP only on one VLAN
on an interface.
The range is from 1 to 4094.
(Optional)
Displays the PTP status.
(Optional)
Displays the status of the PTP port.
(Optional)
Copies the running configuration to the startup
configuration.
Document Title
Cisco IP Fabric for Media Solution video
Configuring IP Fabric for Media
Imprimir página