Cisco SG 300-10P Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Enrutador de red Cisco SG 300-10P. Cisco SG 300-10P 17 páginas. Managed switches
También para Cisco SG 300-10P: Ficha de datos (14 páginas), Especificaciones (2 páginas), Manual de configuración rápida (10 páginas), Manual de inicio rápido (18 páginas), Manual de inicio rápido (17 páginas), Manual de inicio rápido (17 páginas)

Insecure mounting may damage the device or cause injury.

ARNING

Cisco is not responsible for damages incurred by insecure wall-

mounting.

Connecting Network Devices

To connect the managed switch to the network:

Connect the Ethernet cable to the Ethernet port of a computer,

TEP

printer, network storage, or other network device.

Connect the other end of the network Ethernet cable to one of the

TEP

numbered managed switch Ethernet ports.

The LED of the port lights if the device connected is active. Refer to

Features of the Cisco Small Business Managed Switch, page 9

for details about the different ports and LEDs on each switch.

Repeat

TEP

the managed switch.

Cisco strongly recommends using Cat5 or better cable for Gigabit

OTE

connectivity. When you connect your network devices, do not exceed

the maximum cabling distance of 100 meters (328 feet). It can take up to

one minute for attached devices or the LAN to be operational after it is

connected. This is normal behavior.

If your switch is one of the PoE models, consider the following:

As a PSE (Power Sourcing Equipment) device, the switch can deliver a

maximum of 15.4 Watts per PoE port to a PD (Powered Device).

Step 1

and

Step 2

for each device you want to connect to

300 Series Managed Switches