CAB HEKTOR 4 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Sistemas de filtración de agua CAB HEKTOR 4. CAB HEKTOR 4 8 páginas. Strip separator

4. Safety Instructions

Caution !

- Hektor may only used to separate PCB boards. Do not use the machine for

any other purpose than it's intended use. The supplier do not take any

responsibility.

- Use only faultless cut tools.

- Attend that the cover is closed during operation.

- When separating PCB's with cover open, protective gloves and goggles should

be worn.

- Keep hands out of the blade area if the compressed air is switched on.

- Disconnect the air after finishing the work.

- Disconnect the power supply after finishing the work by using a suction

device.

5. Connections

Fig. 1 Compressed air connection

Compressed air connection

- Use only waterfree and filtered compressed air.

- Put the compressed air tube, which is used for the pressure air supply, into the socket (2)

belonging to it.

- Connect the compressed air tube at the pressure air supply.

- The valve of the pressure regulator is adjusted at 6 bar working pressure. It is shown at the

manometer.

The working pressure may not be greater than 6 bar (limited by the stability of the blades).

A working pressure less than 3 bar is not adjustable.

- If you would like to operate with another working pressure or if it is necessary to adjust it you

have to open the valve of the pressure regulator.

Pull the hood (1) out and adjust the pressure. Press the hood (1) in.