CAB HYBRA 24 Manual - Página 14

Navegue en línea o descargue pdf Manual para Abrepuertas CAB HYBRA 24. CAB HYBRA 24 17 páginas.

Imprimir página

1. Technical Data

9) DIAGNOSTICS

SWO1

SWO2

SWC1

SWC2

P.P.

PED

OPEN

PHOT

STOP

PHOT-C

DAS

10) ERROR MESSAGES

Some messages that are displayed in case of function anomalies are listed as follows:

Obstacle error motor 1/anti-crushing

Amp1

Obstacle error motor 2/anti-crushing

Amp2

Error, encoder 1/detection of the obstacle

ENC1

Error, encoder 2/detection of the obstacle

ENC2

Err1

Motor 1 circuit checking error

Err2

Motor 2 circuit checking error

error/fault power circuit

Err3

PHOTA photocell checking error

Err4

Err5

PHOTC photocell checking error

Err6

Error edge active (during autoset)

Error active stop (during autoset)

Err7

Error active input (during autoset)

Err8

Motor 1 thermal protection intervention

thm1

Motor 2 thermal protection intervention

thm2

Motor 1 communication error

COM1

Motor 2 communication error

COM2

Activating BAR input

BAR

One segment of the display is linked to each input. In the event of failure it switches on according

to the following scheme.

N.C. inputs are represented by the vertical segments. N.O. inputs are represented by the horizontal

segments.

The control unit sees the message AMP1 or AMP2 in case of anti-crushing ammeter sensor inter-

vention.

Check presence of obstacles on motor 1 leaf run

Check presence of obstacles on motor 2 leaf run

Check the correct connection of motor 1 encoder to the control unit, that no obstacles

are present along the gate stoke and the encoder operates correctly.

Check the correct connection of motor 2 encoder to the control unit, that no obstacles

are present along the gate stoke and the encoder operates correctly.

Check motor 1 connections

Check motor 2 connections

Request technical assistance and eventually replace control unit.

Check connections, PHOT A photocell alignment or presence of obstacles.

Check connections, PHOTC photocell alignment or presence of obstacles.

In autoset phase, the safety edge has intervened.

In autoset phase, the STOP input has intervened.

In autoset phase a PP/Open/Close input has intervened.

Wait for motor M1 cooling, in case reset does not take place, motor replacement may

be necessary

Wait for motor M2 cooling, in case reset does not take place, motor replacement may

be necessary

Only for HD.3524 and HD.5024 motors: Communication error between motor Encoder

and central unit, check Motor 1 Encoder connections

Only for HD.3524 and HD.5024 motors: Communication error between motor Encoder

and central unit, check Motor 2 Encoder connections

BAR input has detected an obstacle.