Cisco SRP 526W Manual de inicio rápido - Página 11

Navegue en línea o descargue pdf Manual de inicio rápido para Enrutador de red Cisco SRP 526W. Cisco SRP 526W 17 páginas. Srp500 series services ready platforms

Imprimir página

Insert the AC power plug into an electrical outlet.

TEP

Orient the antenna to the vertical position.

TEP

Press the On/Off switch to the on position.

TEP

The POWER/SYS light on the front panel flashes green while the

SRP boots. After booting, the light turns solid green.

The hardware installation is now complete.

Verifying the Hardware Installation

To verify the hardware installation, complete these tasks:

• Check the cable connections.

• Check the lights, as described in

the POWER/SYS light is solid green.

If you encounter problems, go to the Cisco Small Business Support

Community website at www.cisco.com/go/smallbizsupport. For technical

documentation and other links, see

Getting Started with the Configuration

After you install the SRP, configure it by using the Setup Wizard.

Before you get started, verify that your computer meets the software

requirements as specified in

Configure your computer to use DHCP for its LAN connection.

TEP

Using an Ethernet cable, connect your computer to an available

LAN port (1-4) on the SRP. Your computer will automatically obtain

an IP address in the 192. 1 68. 1 5.x range.

Start a web browser.

TEP

In the Address bar, enter the default IP address:

http://192.168.15.1

When the login page appears, enter the username and password.

TEP

The default username is cisco.

The default password is cisco.

Passwords are case sensitive.

OTE

Click Log In.

TEP

Cisco SRP500 Services Ready Platforms Quick Start Guide (SRP520 Models)

Front Panel Lights, page

Where to Go From Here, page

Before You Begin, page

5. Verify that

13.