Cisco AIR-LAP1141N-A-K9 - Aironet 1141 - Wireless Access Point Manual de introducción - Página 10

Navegue en línea o descargue pdf Manual de introducción para Punto de acceso inalámbrico Cisco AIR-LAP1141N-A-K9 - Aironet 1141 - Wireless Access Point. Cisco AIR-LAP1141N-A-K9 - Aironet 1141 - Wireless Access Point 35 páginas. Lightweight access point

Imprimir página

Cisco AIR-LAP1141N-A-K9 - Aironet 1141 - Wireless Access Point Manual de introducción

e. CAPWAP UDP ports must not be blocked in the network.

f. The access point must be able to find the IP address of the controller. This can be

accomplished using DHCP, DNS, or IP subnet broadcast. This guide describes the DHCP

method to convey the controller IP address. For other methods, refer to the product

documentation. See also the "Using DHCP Option 43" section on page 14 for more

information.

Apply power to the access point:

Step 2

a. The access point is 802.3af (15.4 W) compliant and can be powered by any of the following

802.3af compliant devices:

2106 controller

–

WS-C3550, WS-C3560, and WS-C3750 switches

–

C1880 switch

–

2600, 2610, 2611, 2621, 2650, and 2651 multiservice platforms

–

2610XM, 2611XM, 2621XM, 2650XM, 2651XM, and 2691 multiservice platforms

–

2811, 2821, and 2851 integrated services routers

–

3620, 3631-telco, 3640, and 3660 multiservice platforms

–

3725 and 3745 multiservice access routers

–

3825 and 3845 integrated services routers

–

The access point can also be powered by any of the following optional external power

sources:

Any 802.3af compliant power injector

–

The 1140 series access point requires a Gigibit Ethernet link to prevent the Ethernet

Note

port from becoming a bottleneck for traffic because wireless traffic speeds exceed

transmit speeds of a 10/100 Ethernet port.

1250 series access point power injector (AIR-PWRINJ4)

–

1100/1200 series access point DC power supply (AIR-PWR-SPLY)

–

b. As the access point attempts to connect to the controller, the LEDs cycle through a green, red,

and amber sequence, which can take up to 5 minutes.

If the access point remains in this mode for more than five minutes, the access point is

Note

unable to find the Master Cisco wireless LAN controller. Check the connection between

the access point and the Cisco wireless LAN controller and be sure that they are on the

same subnet.