Argent 107509 Instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación para Mezclador Argent 107509. Argent 107509 2 páginas. Zen basin set

Imprimir página
FIT B A SIN SPOUT
Install basin spout
(1)
to basin/
bench ensuring washer & seal
ring
(2)
&
(3)
are fitted to the
107509
centre outlet hole.
NOTE: For O-ring identification
please refer to the O-ring
Template.
FIT 'T' PIEC E
Measure basin tap hole centres
and cut the 'T' piece
(5)
to
required length to suit bodies
(7)
and fit the two O-rings
(6)
with
silicon based grease to the centre
spigot on the copper 'T' piece.
FIT B OD Y ASSEMB LY
Fit body assembly
(7)
to basin/
bench top ensuring that the back
nut & washer
(8)
&
(9)
are fitted
prior to assembly.
Fit body nut
(11)
from the top
of basin / bench top ensuring
sealing O-ring
(8)
is fitted to
seal the top of basin / bench top
opening.
Tighten nut
(9)
onto body
assembly
(7)
107409
1
1
2
3
4
8
11
8
8
6
9
5
7
C
CLOSE
DIRECTION
20
3 Grub Screws
18
19
17
16
15
14
13
12
A S S E M B L E A N D F I T DR ES S F I T T I NG S
C
(17)
(18)
Fit O-ring
to spline
11
apply silicon based grease.
Seal around tap bodies with
approved sealant to ensure
8
the basin top is water tight,
9
tighten all back nuts fitted to
underside.
Fit O-ring
(12)
to underside
of dress flange
(13)
and use
7
flange nut
(14)
to tighten down
over body assembly (7). Ensure
alignment of square flanges.
Fit nylon snap connector
to spindle shaft and secure with
locating screw (16).
Do not over tighten this
screw!
Ensure O-ring (17) on spline is
lubricated prior to engaging!
20
O-ring (6)
3 Grub Screws
18
19
17
16
15
O-ring (17)
14
QTY 2
13
12
O-ring (12)
and
Ensure ceramic valve is in a
closed/off position (CLOSE
DIRECTION)
Possition spline
(18)
onto
snap connector
(15)
DO NOT SNAP ON YET!
Insert handle
(20)
into spline
(18)
and align with flange
(13)
Use one grub screw
(19)
to
fasten handle to spline
(18)
then remove handle & spline
and add remaining 2 grub
(15)
screws (19).
S UITABL E GR EAS E
Press fit handle and spline
to nylon snap connector
(15)
untill it clicks ensuring
alignment of handle to flange
approved silicon based grease to avoid
and 'H' & 'C' indicators.
O-ring Template
QTY 2
Flat Washer (3)-(8)
QTY 5
QTY 2
O-ring (2)
QTY 1
US AGE
Please use AS/NZS 4020
deterioration of O-Rings.