Argent BETTE Manual de instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Bañeras Argent BETTE. Argent BETTE 6 páginas.
9 Trouble shooting guide
SITUATION
ACTION
Whirlpool wont start 1) Check to make
sure that the power
is connected and
turned on.
2) is water level
50mm above the
highest jet
No air, just water
Page 6, turn air ven-
coming out of jet
turis anti clock wise
to open.
Sanitising system
Page 7, Check that
does not start.
there is product in
the reservoir
Light will not turn
Check to make
on
sure that the power
is connected and
turned on.
No access panel
Contact your build-
er/ installer as there
was a kit supplied
with your whirlpool.
9
ALTERNATIVE RESULT
1) Use an appliance
1 & 2) Still wont
that you know works
start, call the
and plug it in to the
Technical advise
power point to check
hotline
the power supply.
2) fill water level
above highest jet
Different air venturis
Still no air coming
operate different
out of jets, call the
banks of jets, check
Technical advise
all air venturis are
hotline
open
Check that indicator
Still wont start,
light is on advising
callthe Technical
that there is power to
advise hotline
the unit
Light will not turn
Still wont start, call
on until whirlpool
the Technical advise
has water above the
hotline
low level sensor
Access panel may
Contact builder/
not be initially
installer as it is there
obvious due to its
responsibility to
discreet nature
facilitate this access.
No access panel =
No service
3 Electrical Supply
The 3 pin plug will need to be reattached by a electrician, this was delibrately
removed after factory testing to ensure this unit is retested on site by a suitably
qualified person prior to connecting to the power supply.
All electrical equipment, including the reattachment of the 3 pin electrical plug to
the whirlpool, should be performed by a qualified person to the National Regulatory
authority requirements.
If a heater has been specified, this system will require 15 amp power connections,
to be installed by an electrician.
The whirlpool control box has been factory sealed; any evidence of tampering with this
item will void the warranty.
4 Access and Framing
The pumps and technical systems of the whirlpool must remain accessible via an access
panel, (one has been supplied with this whirlpool, which will allow for a variable
access panel sizing of up to 400mm high x 1000mm wide, the maximum weight of the
completed access panel should not exceed 12 kg's).
This access panel must be completely removable. Minimum recommended size of access
panel should be 300mm high x 450mm wide and positioned in a location that allows for
access to and or removal to all components and pumps. Whirlpools with heaters will need
additional access opening to allow for service on the heater if required.
The access panel system allows you to tailor the opening to any tile sizing, allowing for a
much more discrete access.
No Access Panel = No Warranty Service
Figure 4, Typical Minimum Access requirement
2