DigitaLinx DL-1H1V1U-WP-W Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Transmisor DigitaLinx DL-1H1V1U-WP-W. DigitaLinx DL-1H1V1U-WP-W 19 páginas.

DL-1H1V1U-WP-W Owners Manual

Connecting Audio

Connect an audio source to the transmitters audio input using a 3.5mm audio cable. The DL-1H1V1U-WP-W

supports a 3.5mm stereo unbalanced input

Connect an audio amplifier to the receivers audio output using a 3.5mm audio cable. The DL-HD2-RX

supports a 3.5mm stereo unbalanced output

Note: The DL-HD2-RX audio output only passes audio fed from the dedicated AUDIO IN port on the

DL-1H1V1U-WP-W transmitter wall plate, it does not pass embedded HDMI audio

Connect the DL-HD2-RX receivers RS232 port to a displays serial connection for serial control.

Note: The DL-HD2-RX RS232 port can be configured to send stored serial commands from the

DL-1H1V1U-WP-W

For directions on RS232 configuration see complete list of control commands on pg13 RS232 / CEC

Control Configuration

Connect the display devices RX RS232 signal to TX port of the DL-HD2-RX receiver. Then connect the displays TX RS232

signal to the RX port on the DL-HD2-RX receiver.

Plug the power supply into the power input port on the rear of DL-HD2-RX receiver. The receiver will power the

transmitter via HDBaseT. Twist the locking ring clockwise to prevent accidental disconnection of power.

DL-SE3H1V-C

Controller or

Device

RXD

TXD

GND