DigitaLinx DL-ARK Series Manual de instalación rápida - Página 3

Navegue en línea o descargue pdf Manual de instalación rápida para Amplificador DigitaLinx DL-ARK Series. DigitaLinx DL-ARK Series 4 páginas.

1. Verify all components included with the DL-ARK A/V system are present before installation.

2. If the receiver is going to be permanently mounted to a surface or A/V box, attach the included

mounting brackets with the supplied screws.

3. Turn off power and disconnect the audio/video equipments by following the manufacturer's

instructions.

4. Connect Category 6 or greater twisted pair cable between the DL-ARK control pad and transmitter

up to 30m / 100', then connect a Category 6 or greater cable between transmitter and the receiver up

to 70m / 232'. TIA/EIA-568B straight-through wiring connections must be used.

5. Connect an HDMI cable no greater in length then 5m / 16' and any desired IR or RS232 control

accessories between the display and the DL-ARK receiver.

6. Connect an HDMI cable no greater than 5m / 16' in length between the source and the DL-ARK

transmitter.

7. Mount the keypad and wall plate transmitter.

8. Connect the included power supply to the DL-ARK receiver and lock the power supply to the power

connector by twisting the locking collar clockwise.

9. Power on attached audio/video devices.

Cabling Wiring Requirements

HDBaseT Cabling

To ensure proper performance of the DL-ARK, it is recommended that you use solid core, shielded

Category 6 F/UTP cabling at a minimum between control pad and transmitter and between transmitter

and receiver. Category 5e F/UTP may perform well but may not support power over HDBaseT reliably

over longer distances.

For optimized HDBaseT performance use the following Liberty Wire and Cable branded cabling;

Category 6 plenum; 24-4P-P-L6SH

Category 6A plenum; 24-4P-P-L6ASH

Category 6 NON-plenum; 24-4P-L6SH

Category 6A NON -plenum; 24-4P-L6ASH

Connectivity Instructions

When using shielded category cabling ALWAYS...

....use shielded connectors

....properly ground the category cable

Twisted Pair Wiring

Use TIA/EIA-568B wiring for Category 6

connection between send and receive

units.

DL-ARK Quick Guide