Epson 3880 - Stylus Pro Color Inkjet Printer Garantía limitada - Página 7

Navegue en línea o descargue pdf Garantía limitada para Impresora todo en uno Epson 3880 - Stylus Pro Color Inkjet Printer. Epson 3880 - Stylus Pro Color Inkjet Printer 12 páginas. Printer
También para Epson 3880 - Stylus Pro Color Inkjet Printer: Folleto (3 páginas), Especificaciones (2 páginas), Manual de la red (39 páginas), Folleto y especificaciones (8 páginas), Empieza aquí (2 páginas), Manual Start Here (6 páginas), Manual de gestión del color (47 páginas), Folleto y especificaciones (8 páginas), Manual de la red (38 páginas), Manual de inicio rápido (2 páginas)

Imprimir página
Epson 3880 - Stylus Pro Color Inkjet Printer Garantía limitada
NOTES:
•
In case shipment of the printer for service becomes necessary, to prevent unrepairable
damage to the printer, the printer should be packaged in its original box and packaging
materials. If you do not have these items, you must contact Epson and Epson will supply
appropriate items for your shipment.
•
The printer is equipped with a pressurized valve system that closes and seals all ink supply
lines. In order for this valve system to properly close, the ink cartridges must be removed
and the ink bay door needs to be closed.
INSTRUCTIONS:
1)
Turn on the printer.
2)
Remove any paper or other media in the printer.
3)
Remove the ink cartridges and close the ink bay door.
Note: To store any partially used cartridges that you take out before shipment, tape over the
needle valve hole until you are ready to use the cartridges again.
4)
Make sure the print head is in the home (far right) position.
5)
Turn off the printer and unplug the power cord. Install the carriage retainer bracket to secure
the print head in place.
CAUTION: Do not turn off the printer by unplugging it or turning off a power strip. You will
not be able to lock the print head in the home position, and ink left inside the reservoir will
leak out, damaging the printer.
WARNING: Components may be hot. After turning off and unplugging the printer, make
sure you allow each component to cool before handling it.