Epson AcuLasaer C1900 Manual de consulta rápida - Página 6
Navegue en línea o descargue pdf Manual de consulta rápida para Impresora todo en uno Epson AcuLasaer C1900. Epson AcuLasaer C1900 17 páginas.
Imprimir páginaPaper Set XXX YYY
The paper loaded in the specified paper
source (XXX) does not match the required
paper size (YYY). Replace the loaded paper
with the correct size paper and press the
Start/Stop button to resume printing. Or
press the
Cancel Job button to cancel the
print job.
If you press the Start/Stop button without
replacing the paper, the printer will print on
the loaded paper even though it does not
match the required size.
Please wait
The developer cartridge to be replaced is
moving to the replacement position in the
printer.
Printer Open
One or more of the following covers are
open; the front cover, Cover AB, Cover DM,
or Cover C.
Print Overrun
The required time to process the print data
exceeded the print engine speed because the
current page is too complex. Press the
Start/Stop button to resume printing. Or
press the
Cancel Job button to cancel the
print job. If this message appears again,
select On as the Page Protect setting in the
control panel's Setup Menu.
If you continue to receive this message when
printing a particular page, try simplifying
the page by limiting the number of graphics
or reducing the number and size of fonts.
You can also add more memory to the
printer as described in "Memory module" in
the Reference Guide.
EPSON AcuLaser C1900 Quick Reference
PS3 Hard Disk full
The memory allocated for writing PostScript
3 commands on the optional Hard Disk
Drive is full.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
RAM Check
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Replace Toner X
The developer cartridge to be replaced has
been moved to the replacement position in
the printer.
Replace Photocondctr
The photoconductor unit has reached the
end of its service life. Replace the
photoconductor unit with a a new one. See
"Photoconductor Unit" in the Reference
Guide for instructions.
The error clears automatically after you
replace the unit and close all printer covers.
The photoconductor service life counter is
reset automatically.
Replace TransferUnit
The transfer unit has reached the end of its
service life. Replace the transfer unit with a
new one. See "Transfer Unit" in the Reference
Guide for instructions.
The error clears automatically after you
replace the unit and close all printer covers.
The transfer unit service life counter is reset
automatically.
Status and Error Messages (5/7)