Cisco Catalyst IW9165E Manual de inicio rápido - Página 11

Navegue en línea o descargue pdf Manual de inicio rápido para Punto de acceso inalámbrico Cisco Catalyst IW9165E. Cisco Catalyst IW9165E 16 páginas.

Imprimir página

Installation Overview

Step 4

If necessary, strip the other end of the ground wire and connect it to a reliable earth ground such as a grounding rod or

appropriate ground point on a grounded pole. Length of the ground cable should not exceed 1 meter, and 0.5 meter is

preferred. Use supplied oxide inhibitor on the grounded interface.

Powering the Access Point

The AP supports these power sources:

• DC power – 24–48 VDC

• Power-over-Ethernet (PoE)

The AP can be powered via the PoE input from an inline power injector or a suitably powered switch port.

Depending on the configuration and regulatory domain, the required power for full operation is 802.3bt or

UPOE.

For more information, see

Power Feature Matrix

The following table provides the AP power feature matrix.

Table 1: Cisco Catalyst IW9165E Feature Matrix

Power Input

24-48V

802.3at

802.3af

Connecting a Power Injector

The AP supports the following power injector:

Table 2: Supporting Power Injectors

Power Source

IW-PWRINJ-60RGDMG=

The power injector provides DC voltage to the AP over the Ethernet cable and supports a total end-to-end

Ethernet cable length of 100 m (328 ft) from the switch to the AP.

When an optional power injector powers your AP, follow these steps to complete the installation:

Step 1

Before applying PoE to the AP, ensure that the AP is grounded (see

Step 2

Connect a CAT5e or better Ethernet cable from your wired LAN network to the power injector.

Power

Sources.

5G Radio

5G/6G Radio

2x2

1x1

Powering the Access Point

GNSS

mGig Eth

Yes

max 2.5G

Yes

max 2.5G

Yes

max 1G

Description

60W rated outdoor power injector, 5GE

Grounding the Access Point, on page

Installation Overview

RJ45 1G

Yes

9).