Cisco Cisco Aironet Wireless LAN Client Manual de inicio rápido - Página 3
Navegue en línea o descargue pdf Manual de inicio rápido para Punto de acceso inalámbrico Cisco Cisco Aironet Wireless LAN Client. Cisco Cisco Aironet Wireless LAN Client 12 páginas.
También para Cisco Cisco Aironet Wireless LAN Client: Manual de introducción (38 páginas)
Imprimir página
2
Connect and Power Up the Access Point
340 Series Access Points
5 V D C
To wall outlet
Adjust the access point antennas.
Step 1
Note Antenna configurations vary depending upon the access point model.
For maximum range, make sure the access point antennas are perpendicular to the ground, no
matter where the access point will be mounted.
If on a table or desk, point the antennas straight up.
If mounted on a wall, point the antennas straight up, even though if the access point is on its
side.
If mounted on the ceiling, point the antennas straight down.
Connect the Ethernet cable from the wired 10/100 Ethernet LAN to the Ethernet connector
Step 2
on the back of the access point.
Plug the power pack connector into the power receptacle on the back of the access point.
Step 3
Plug the power pack into a wall outlet or power strip.
Step 4
Note At start-up, all three LEDs on the top of the access point slowly blink amber,
red, and green in sequence; the sequence takes a couple of minutes to complete.
Refer to the software configuration guide on the CD for LED descriptions.
5 V D C
S E R IA L
E T H E R N
E T
To 10/100 Ethernet LAN
E T H E R N
E T
3