Digitaltech-Market EDIC-mini Tiny16+ Manual operativo - Página 8

Navegue en línea o descargue pdf Manual operativo para Grabadora de voz Digitaltech-Market EDIC-mini Tiny16+. Digitaltech-Market EDIC-mini Tiny16+ 11 páginas. Dvr

Imprimir página

In case of signal level exceeding the preset threshold, indication while recording with

VAS is the same as during standard recording (two series of flashes). In case of signal

below threshold (silence), there is constant faint glow of LED.

When uploading record onto the PC, you can specify the operations with pauses: save

them in the file uploaded or not. If you save pauses, the duration of the resulting record

will correspond to the actual one, and the fragments when the signal was below threshold

will be played back silent. If the pauses are not saved, then the resulting record will

consist of recorded parts only (signal exceeds the threshold). These parts will be played

one after another without interruption.

Configuring VAS

Voice Activation System (VAS) is configured in the EMPlus program by changing two

parameters: VAS threshold level and VAS time.

VAS level can be adjusted from 0 to -55 dB. 0 dB corresponds to very low sensitivity

(the device records only very loud sounds) and the value of -55 dB to very high

sensitivity (the slightest rustle is enough for the recorder to start recording). The best of

VAS is achieved experimentally. You can start by setting VAS level at - 20 dB (after you

have changed the settings, do not forget to press the button «Apply changes to the

Recorder»).

After disconnecting the recorder off the PC enable recording and place it in the

conditions similar to the planned recording (for example, lecture in a classroom). With

the level of VAS properly configured, after the desired signal, the recorder switches to

record mode which will be indicated by a LED flashing. If desired signal stops, and the

VAS time is up, the recorder switches to Signal Standby mode.

If in case of silence, the recorder does not go to Signal Standby Mode and continues

recording, VAS level is to be changed to be closer to zero (if it was -20 dB, now it should

be set at -17 dB).

If when desired signal appears the recorder does not go to Record Mode, the level of

VAS should be changed to be closer to -55 dB (if it was - 20 dB, now you need to set it at

- 25 dB).

VAS time is adjusted from 1 to 15 seconds. If you set VAS time at 1 second, the record

within the file will be divided into many pieces with the pauses in conversation for more

than 1 second. If you set 15 seconds, after any knocking the recorder will continue

recording silence for 15 seconds. The best of VAS is achieved experimentally, but for

most cases the value of 7 seconds is enough.

If VAS operates together with timers, you don't have to enable recording as it starts

automatically with the timer, providing that you synchronized the recorder's time with the

time on the PC.