CABINETS TO GO Findley & Myers AB124 Instrucciones de montaje - Página 2
Navegue en línea o descargue pdf Instrucciones de montaje para Mobiliario interior CABINETS TO GO Findley & Myers AB124. CABINETS TO GO Findley & Myers AB124 4 páginas. Angle base cabinets
También para CABINETS TO GO Findley & Myers AB124: Manual de instrucciones de montaje (7 páginas)
Imprimir página
►General Instructions:
Thank you for purchasing a Cabinets To Go product. You are now the proud owner of a high quality product designed
to face the test of daily use and guaranteeing your enjoyment for many years to come.
Carefully read the instructions before starting the installation.
During assembly, please follow all generally accepted safety procedures.
Failure to adhere to the following instructions will invalidate the warranty and Cabinets To Go will decline any responsibility for any
damages caused. Any installation which does not correspond to the instructions may result in defects, malfunctioning parts, significant
damage and/or injury.
Before the assembly begins, check that all appropriate and required plumbing and electrical connections exist.
Before drilling, make absolutely sure that there are no pipes (gas, water,electricity, heating, etc.) at the drilling location. Cabinets To Go will
not be held responsible for failure to follow these instructions.
PRIOR TO ASSEMBLY, PLEASE MAKE SURE YOU HAVE ONE FACE FRAME BOX AND ONE CARCASS BOX, WHICH HAVE ALL THE PARTS IN THE
QUANTITIES MENTIONED BELOW. IF YOU ARE MISSING ANY PARTS, PLEASE STOP AND CONTACT CUSTOMER CARE IMMEDIATELY AT 1-800-
CABINET.
► Items Quantity
Item
Description
A
Face Frame and Door
B
Side Panel
C
Bottom Panel
D
Back Panel
E
Shelf
F
Toe Kicks
G
Hardware Box
Bumper 4pcs, Plastic corner bracket 1pcs, "L" brackets 2pcs , Wood corner brackets 3pcs, 1/2" Flat Head Screws 4pcs, 1/2" Round Head Screws 2pcs,
1" Flat Head Coarse Thread Screws 14pcs, 1" Flat Head Screws 4pcs
► Required tools:
1/16"
Tools Required: Phillips Screwdriver
Optional Tools: Electric Drill
► Hardware Box:
a
b
c
4
1
4
Qty
Q ty
Qty
The materials listing above are for the largest unit in this instruction set. Smaller units may require less hardware and materials;
therefore, your item may contain a smaller number of each.
Optional Tools: Rubber Mallet
d
e
f
g
t
2
14
Q
y
Qty
4
2
Qty
Qty
h
3
Qty
Page 2
Qty
2
1
1
1
1
2
1