Cisco WAP571E Manual de inicio rápido - Página 3
Navegue en línea o descargue pdf Manual de inicio rápido para Punto de acceso inalámbrico Cisco WAP571E. Cisco WAP571E 17 páginas. Manually connect access points to the network via power over ethernet (poe)
También para Cisco WAP571E: Manual (4 páginas), Manual de inicio rápido (6 páginas)
Cisco WAP571E Wireless-AC/N Premium
2
Dual Radio Outdoor Access Point Features
Front Panel
The front panel of the device consists of a single system LED. For a full
description of the colors of the light and its indications, see
Hardware
Installation.
Back Panel
The back panel of the device has a water proof RJ-45 Ethernet port and
reset bottom. Facing the side of the device, the right port (labeled
"ETH0/PD") is an 802.3at and 802.3af Power over Ethernet (PoE) port
which is used to power your device. The left port (labeled "ETH1") is a
general Gigabit Ethernet LAN interface. Both are auto-sensing, Gigabit
Ethernet (802.3) ports used to connect your WAP devices to network
devices, such as computers, routers, or switches. We strongly
recommend that you use a Category 5e or better cable for Gigabit
connectivity.
Side Panel
The side panel of the device has a Reset button at right. See
the Devices or Returning them to their Factory Default Settings
information on the Reset button.
Default Setting
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
If your network does not have an existing DHCP server, the WAP571E will
start a DHCP server for WLAN stations and stop the DHCP client when
WAP571E is in factory default. The DHCP server will assign the IP address
from 192.168.1.20 to 192.168.1.100.
Cisco WAP571E Wireless Access Point
Default Value
cisco
cisco
DHCP address assigned
by server
192.168.1.245
255.255.255.0
Verifying the
Rebooting
for
2