CabKing 8V1 Manual de instrucciones - Página 15

Navegue en línea o descargue pdf Manual de instrucciones para Torno CabKing 8V1. CabKing 8V1 20 páginas.

CABKING WATER SYSTEM PARTS

One of the key features to the CabKing-8V1 is the single pass, contamination-free water

system. The water system will remain trouble-free as long as you use a fresh, clean

supply of water. Do this by using a separate intake water bucket from the drainage

bucket. A fresh supply of water will protect you from cross-contamination of grit which

can occur in re-circulating systems that use a bubbler or geyser. With fresh water, the

pump and intake tubes will stay clean and unobstructed so there will be enough water

pressure. The water pump is rated at 30watts, 605GPH, 8.2ftHmax. We recommend

using a minimum 5 gallon bucket for both the water pump and drainage. You will

typically go through an average of 1-2 gallons of water per hour, with the water control

knobs on a light to medium drip. Monitor the water level in the bucket to make sure the

water pump is always submerged in water. THE WATER PUMP SHOULD NOT BE RUN

DRY.

By design, all water system parts can be easily disassembled by pulling off or

unscrewing and cleaned with soapy water. For routine maintenance, keep the nozzles, y-

split and tubing clean with a small wire brush or the included pipe cleaner.

DO NOT SET-UP THE WATER SYSTEM AS A RE-CIRCULATING SYSTEM. THIS WILL

VOID YOUR WARRANTY. This means putting the drip pan tubes into the same bucket

of water as your water pump. Doing so will void your warranty and you also risk

cross-contamination of grit, which may result in scratches on your stone. The grit will

eventually build up in the water control valves, nozzles and tubing which will restrict

water flow and potentially clog the water system parts.

Underneath each hood are three y-splits with two nozzles in each, three needle valves

and clear tubing that connects to each needle valve. The clear tubing measures 1/4"

outer diameter X 1/8" inner diameter. See image below to identify parts.

Nozzle

Y-split

Clear tubing

Needle valve