Cisco Profile Series Manual de instalación - Página 11

Navegue en línea o descargue pdf Manual de instalación para Sistema de conferencias Cisco Profile Series. Cisco Profile Series 16 páginas. Jbod on the 12g sas modular raid controller
También para Cisco Profile Series: Manual de introducción (41 páginas), Manual del usuario (44 páginas), Manual del usuario (7 páginas), Manual de introducción (35 páginas), Manual de consulta rápida (2 páginas), Manual de instalación (44 páginas), Manual de configuración (13 páginas), Hoja de instalación (2 páginas), Manual de instalación (2 páginas), Manual de inicio rápido (4 páginas), Manual de inicio rápido (4 páginas), Manual de introducción (32 páginas), Manual (16 páginas), Manual de introducción (42 páginas), Manual de introducción (46 páginas)

Chapter 2

Installing the Router

Manually screw the antenna tight to the TNC connectors in front side of the 3G Module. See

Step 2

Figure 2-11

Orient the antennas as required. For optimum wireless performance, antennas should be perpendicular

Step 3

to each other. If the router is being mounted on a desk, orient the antennas straight up.

Installing the Router Ground Connection

The router must be connected to a reliable earth ground. Install the ground wire in accordance with local

electrical safety standards.

•

This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect

Warning

the host to earth ground during normal use. Statement 242

To install the ground connection, follow these steps:

Step 1

Strip one end of the ground wire to the length required for the terminal.

Crimp the ground wire to the ring terminal using the wire crimper.

Step 2

If you choose to install the power switch lock, perform

Step 3

Step 6

Attach the ring terminal to the chassis. Use the single screw provided. Tighten the screws to a torque of

Step 4

8 to 10 inch-pound (0.9 to 1.1 newton meter) as shown in

Installing Antennas

For NEC-compliant grounding, use size 14 AWG (2 mm2) or larger copper wire and a ring terminal

with an inner diameter of 1/4 in. (5 to 7 mm).

For EN/IEC 60950-compliant grounding, use size 18 AWG (1 mm2) or larger copper wire.

and

Step

Step 5

Cisco 800M Series Integrated Services Router Hardware Installation Guide

Step

7. Otherwise, perform

Figure

2-12.

Figure

2-11.

Step

2-11