Cisco Profile Series Manual de introducción - Página 21

Navegue en línea o descargue pdf Manual de introducción para Sistema de conferencias Cisco Profile Series. Cisco Profile Series 42 páginas. Jbod on the 12g sas modular raid controller
También para Cisco Profile Series: Manual de introducción (41 páginas), Manual del usuario (44 páginas), Manual del usuario (7 páginas), Manual de introducción (35 páginas), Manual de consulta rápida (2 páginas), Manual de instalación (44 páginas), Manual de configuración (13 páginas), Hoja de instalación (2 páginas), Manual de instalación (2 páginas), Manual de inicio rápido (4 páginas), Manual de inicio rápido (4 páginas), Manual de instalación (16 páginas), Manual de introducción (32 páginas), Manual (16 páginas), Manual de introducción (46 páginas)

Imprimir página
Cisco Profile Series Manual de introducción
Cisco TelePresence Video Systems
Contents
Setting date, time and location
(when not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among other
things this information is used to time stamp messages trans-
mitted to gatekeepers and other network elements.
the time and date is shown in the top right corner of the main
display. it takes a few moments before the time on the screen
changes after changing the setup.
Always save the new value when you change a setting
•
drop down list selection: Navigate to the correct value
and press the
OK
( )
key to save, or press the left arrow
key
to leave without saving.
•
text entry in an input field: enter the text, navigate to
Save
to save the change, or navigate to
without saving; then press the
OK
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction
User interfaces
1. Go to
Home > Settings > Date and
2. Select
24 hours
drop down list as you prefer.
3. Select Day.Month.Year,
in the
Date format
4. Select your time zone in the
5. Select Auto,
list as you prefer.
if you select Manual, also enter the
in the corresponding input field.
if you select
Month,
6. Press
Home
NtP mode:
1
Auto:
the time is regularly updated using an NtP server. the
NtP server address is automatically obtained from the
network (dHCP).
Manual: the time is regularly updated using an NtP server. You
must manually enter the NtP server address.
Off:
You must set the time manually. the time is not
Ok/
updated automatically.
Cancel
to leave
( ) key
to confirm.
Confirguration
Configuration
time.
or
12 hours (am/pm)
in the
Time format
Month.Day.Year
or
Year.Month.Day
drop down list as you prefer.
Time zone
drop down list.
Manual
or
Off
in the
NTP mode
drop down
1
NTP server
Off,
also select the correct value for Day,
Year
and
Time
in the corresponding drop down lists.
(
)
to exit.
21
Appendices
address
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts