Argo CLIMIA CMK 4000 WiFi Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Aire acondicionado Argo CLIMIA CMK 4000 WiFi. Argo CLIMIA CMK 4000 WiFi 20 páginas. Room air conditioner with remote condenser
Imprimir páginaCLIMIA
06 - AIR CONDITIONER INSTALLATION
The air conditioner is made of two units interconnected by a flexible
tube. The indoor unit must be placed in the room to be air condi-
tioned, near a window, a balcony-door or a perimeter wall. The out-
door unit, that provides to the disposal of heat and condensation,
must be located outside, on a window sill, on a balcony or hanged
to the wall.
NOTE
It is strongly recommended to place a neutral pad under the feet of
the unit to protect the floor from possible indentations.
Place the outdoor unit, which dissipates the heat and through which
the condensed water is disposed of, on the balcony, on a window sill
or hang it on the outside wall.
POSITIONING OF OUTDOOR UNIT
The outdoor unit must always be kept in vertical position and le-
velled. Make sure that there are no obstacles around the unit affec-
ting the free circulation of air. A lug at the rear bottom of the unit
ensures the minimum distance from the wall (3 cm). The unit must be
kept at a minimum distance of cm. 15 (sidewise) and cm. 80 (frontally)
from any walls.
INSTALLATION TYPE A
If your room has a balcony or a window-sill of sufficient depth (min.
25 cm) you may rest the unit freely onto it. For safety's sake, you may
anchor the unit to the window-sill using one M6 x 20 expansion bolt in
the slot of the lug at the rear bottom of the unit. The flexible tube may
easily pass through the balcony door or window shutters set ajar.
INSTALLATION TYPE B USING THE OUTDOOR UNIT SUPPORT BRACKET
KIT (NOT SUPPLIED)
You can buy separately the support bracket kit to fix the outdoor unit
to the wall, as follows:
1. Fix the support guide to the wall below the window sill.
2. Insert the support in the handle of outdoor unit, and turn the out-
door unit upside down as shown in the picture.
3. Place the support and secure it at the edge of the unit, using the
screws.
4. Insert the support, fixed on the unit, at the guide fixed to the wall.
Make sure it is levelled.
IMPORTANT ADVICE
IMPORTANT ADVICEOUTDOOR UNIT
1. When you move the outdoor unit, always hold it by the handle, never pull it by the flexible tube.
2. Never let the outdoor unit hang on the flexible tube.
3. When you recover the outdoor unit after operation, drain away any remaining condensate by tilting the unit.
4
NEIN!
NO!
TYP A
TYPE A
Löcher
Holes
3 x ø 10
WAND-
Wall mount
HALTERUNG
TYPE B
TYP B
NEIN!
NO!
M6 x 20
M6 x 20
Min. 25 cm.
Bracket
HALTER