Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
Web interface
Configuring IP
(when not set by a provisioning system)
Your video conference system supports both IP version 4
(IPv4) and IP version 6 (IPv6).
In both cases, the IP parameters can be assigned
automatically by the network, or you can set everything
manually.
If you want to set the parameters manually please
contact your network administrator to obtain the required
parameters.
If an IP address is already assigned to your system, you will
find the current IPv4 and/or IPv6 address on the System
Information page:
Go to the
Diagnostics
tab and select
The system's IP address is listed in the General section.
Back to task overview
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
User interfaces
1. Select IP version
Go to the
Configuration
Configuration.
Open the
Network 1
which IP version to use in the
2. Select automatic or manual IP assignment
For IPv4: Select
down list.
For IPv6: Scroll down the page to the
select
Autoconf
list.
System
Information.
IPStack
IPv4
IPv6
Configuration
Configuration
Appendices
tab and select
Advanced
settings from the left column. Select
IPStack
drop down list.
DHCP
or
Static
in the
Assignment
drop
IPv6
section and
or
Static
in the
Assignment
drop down
DHCP/Autoconf
The IP configuration is complete.
a. Select
On
or
Off
in the
DHCPOptions
down list according to your preference.
DHCP Options:
1
Off: All IP parameters, except the IP address and gateway, must be set manually.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.
3. Set the IP addresses
Set the remaining IP settings according to the table
below. The actions required depend on the IP version
(IPStack) and IP assignment method (Assignment) you
selected in the previous steps.
Assignment
Static
a. Under the heading IPv4; enter the
Address,
Gateway
and
SubnetMask
corresponding input fields. Click
the change.
b. Under the heading DNS, enter the DNS
server address in the
Server 1 Address
field. Click
ok
to save the change.
drop
a. Select
On
or
Off
in the
DHCPOptions
down list according to your preference.
1
b. Enter the system IP address in the
input field and the gateway address in the
Gateway
input field. Click
change.
26
in the
ok
to save
input
drop
1
Address
ok
to save the
www.cisco.com
Imprimir página