Cisco TelePresence MX700 Manual de instalación - Página 29

Navegue en línea o descargue pdf Manual de instalación para Sistema de conferencias Cisco TelePresence MX700. Cisco TelePresence MX700 32 páginas. Single camera on a free standing floor stand or a floor stand secured to the wall
También para Cisco TelePresence MX700: Manual de inicio rápido (12 páginas), Manual de instalación (28 páginas), Manual de instalación (29 páginas), Manual de instalación (32 páginas), Manual de consulta rápida (2 páginas), Manual (45 páginas), Manual (45 páginas), Manual de instalación (29 páginas), Manual de consulta rápida (2 páginas), Manual de consulta rápida (2 páginas), Manual de introducción (46 páginas)

Installation guide for Cisco TelePresence MX700 Dual camera - Wall mount

Start up the system

•

Remove the protection foil from the displays.

•

Make sure the cameras can move freely.

•

Insert the network and power cables into the wall outlets.

•

Switch on the system.

The power switch is located directly below the codec, next to

the power connector.

Wait a few minutes while the system starts up. The start-up

may include automatic software upgrade and restart of

Touch 10 and cameras.

•

Follow the instructions on Touch 10.

If your system is not set up to be automatically provisioned,

you must configure the system before you can make your

first call. This is described in the Getting Started Guide, which

can be found on the Cisco web site.

Page 29