Cisco Telepresence MX800 Manual de introducción - Página 30

Navegue en línea o descargue pdf Manual de introducción para Sistema de conferencias Cisco Telepresence MX800. Cisco Telepresence MX800 46 páginas. Wall-mounted mx800 single
También para Cisco Telepresence MX800: Manual de inicio rápido (12 páginas), Manual de instalación (16 páginas), Manual de sustitución (46 páginas), Manual de sustitución (47 páginas), Manual de instalación (30 páginas), Piezas de recambio (24 páginas), Manual de instalación (16 páginas), Manual de consulta rápida (2 páginas), Manual (45 páginas), Manual (45 páginas), Manual de consulta rápida (2 páginas), Manual de consulta rápida (2 páginas)

Imprimir página

Cisco Telepresence MX800 Manual de introducción

Cisco TelePresence Video Systems

Contents

IP settings

(When not set by a provisioning system)

The IP parameters can be assigned automatically by the

network, or you can set everything manually. If your system

is provisioned automatically, these IP settings may be overrid-

den by the provisioning system.

If you want to set the parameters manually, please contact

your network administrator to obtain the required parameters.

If an IPv4 address is already assigned to the system, you will

find it under Settings: Navigate to the user name in the upper

left corner and select

Settings.

To change the IPv4 settings, navigate to the user name in the

upper left corner and select Settings. Select

and proceed to the IPv4 section.

If you wish to change the IP settings from the default dual

stack setting to either IPv4 or IPv6, this can be done on the

web interface.

NOTE:

When you start up the SX10 for the first time, the

Setup assistant starts automatically.

Back to task overview

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

Choose automatic or manual IP assignment

Select

DHCP

assignment; or

manually.

Setup

Assistant,

If IP Assignment is Static: Set the IP addresses

Enter the

A soft keyboard appears when you select an input field.

Select

⎷

to confirm the change.

3. Select

Apply

Configuration

in the

IP Assignment

section for automatic IP

Static

if you want to set the IP addresses

Address,

Subnet Mask

and

Gateway

to save the changes.

Appendices

address.

Getting Started Guide

Contacts