Sony 10001 Manual de instalación - Página 10

Navegue en línea o descargue pdf Manual de instalación para Videocámara Sony 10001. Sony 10001 50 páginas. A/v multiplexer board, a/v demultiplexer board
También para Sony 10001: Manual de instalación (28 páginas)

Imprimir página

1. Setup Menu Settings

1-6. Rack Mounting

Explains how to mount this unit into a 19-inch standard rack.

Be sure to mount this unit into a rack accurately following

the procedure and notes mentioned below.

. Use the specified rack mount rail.

The use of other rail of low strength may drop the unit

and cause the risk of injury.

. To prevent toppling over the rack, fix it on the horizontal

and firm floor securely with bolts, etc.

. Mount the unit into a rack with a steady posture.

. When other equipment with built-in hard disk drive is

already mounted in the same rack for mounting this unit,

turn off the power of the equipment before mounting this

unit.

. Connect long enough cables on the connector panel,

considering that the unit is pulled out from the rack.

. Do not operate this unit without the upper lid and bottom

plate except when servicing it.

. To reduce an increase in the internal temperature of this

unit, leave a space on the top or bottom of this unit by

1U.

. Adjust the temperature inside the rack within the range

of the unit's operating temperature.

(Refer to Section 1-3.)

Specified Rack Mount Kit

RMM-111 (Option) or

RMM-110 (Option)

The color of rack angle of RMM-111 fits to the unit.

RMM-110 is the same consistance, strength and dimension

as RMM-111, but the color of rack angle is different.

To mount this unit into the FLEXICART, it is recommend-

ed to use the BKFC-53/2.

1-4

Parts Packed in RMM-110/111

. Slide rails ......................................... 2

. Rack angles (handles) ..................... 2

. Rail brackets .................................... 4

. Plate nuts (large) ............................. 4

. Plate nuts (small) ............................. 4

. Screws (PSW4 x 16) ...................... 4

. Screws (B4 x 8) .............................. 8

. Hexagon socket head cap screws .... 8

. Flat washers ..................................... 8

. Screws (RK5 x 14) ......................... 2

. Ornamental washers ........................ 2

. L-shaped hexagon wrench .............. 1

Rack Mounting Procedure

. Remove of feet

1. Set the unit with its side panel down.

Lend your hand so that the lower handle does not hang

down.

2. Unscrew the four screws to remove the feet from the

bottom plate of the unit.

3. Set the unit in a horizontal position.

Foot

Keep these screws and the feet.

When operating the unit after demounting it from the rack,

be sure to reattach the feet.

Tightening torque: 98 x 10

PS4 x 20

N . m {10 kgf . cm}

DNW-75/75P

DNW-65/65P