Sony BRC-X400 Lista de comandos - Página 9

Navegue en línea o descargue pdf Lista de comandos para Videocámara Sony BRC-X400. Sony BRC-X400 41 páginas. Srt introduction
También para Sony BRC-X400: Manual (15 páginas), Manual técnico (15 páginas)

Imprimir página

VISCA over IP

Overview of VISCA over IP

With VISCA over IP function, you can control the

camera using VISCA on a controller equipped

with IP communication capabilities via LAN. You

can connect up to 5 controllers simultaneously

on the network.

The communication specifications of VISCA over

IP are as follows:

• Interface

RJ-45 10BASE-T/100BASE-TX/1000BASE-T

(automatically identifying)

• Internet protocol

IPv4

• Transport protocol

UDP

• IP address

Set by the IP setting command (page 41)

• Port address

52381

• Delivery confirmation/Retransmission

control

Depends on the application

In these instructions, the device outputting

commands, such as a computer, is called the

controller, and the device receiving the

command, such as a BRC/SRG series camera, is

called a peripheral device.

The controllers and peripheral devices are

connected to a one-direction ring conforming to

RS-422 standards. On the IP communication

connection, the controllers and peripheral

devices are connected by bus through a LAN.

RS422 connection

IP communication connection

While the IP communication connection, the

address of each device cannot be set in the

VISCA message as it is because the controllers

and peripheral devices that are connected

simultaneously are increased. In this case,

addresses of the controllers and peripheral

devices that are set in the VISCA message are

Network