DigiTech XC0438 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Estación meteorológica DigiTech XC0438. DigiTech XC0438 16 páginas. Smart wi-fi weather station lcd colour display

Imprimir página

1. Installation and Setup

WIRELESS THERMO-HYGRO SENSOR

1 . LED indicator

2 . Wall mounting holder

3 . Channel slide switch

4 . [ RESET ] key

5 . Battery compartment

INSTALLATION AND SETUP

INSTALL WIRELESS THERMO-HYGRO SENSOR

1 . Remove the battery cover of the sensor.

2 . Use the channel slide switch to set the channel number for the

sensor (e .g . Channel 1)

3 . Insert 2 x AA size batteries into the battery compartment according

to the polarity marked on the battery compartment, and close the

battery cover .

4 . The sensor is in synchronization mode, and can be registered to the

console within the next few minutes . The transmission status LED

will begin to flash every 1 minute.

NOTE:

- If you need to re-assign the sensor channel, slide the channel slide switch to the new channel

position and press the [ RESET ] key on the sensor for the new channel number to be effective.

- Avoid placing the sensors in direct sunlight, rain or snow.

- To avoid the sensor/s and console pairing failure during new console setup, please power up the

rst, and then press [ SENSOR/WiFi ] key on the main unit.

PLACING THE WIRELESS THERMO-HYGRO SENSOR

Place a screw on the wall that you wish to hang the sensor on .

Hang the sensor onto the screw by the wall mounting holder . You

can also place the sensor on a table by itself .