Argo Relax Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Aire acondicionado Argo Relax. Argo Relax 13 páginas.
Imprimir página
1. COOL MODE
• The first time it is turned on, the air conditioner will operate in Cooling mode with the temperature set to 25ºC by
default.
• The control panel Cool led will turn on.
• The temperature can be adjusted from 16° to 30°C.
• In this mode, each time the ON/OFF button is pressed, the unit switches off, the appliance saves the temperature
setting and, when switched back on again, it will retain this setting.
• In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.
• For more silent operation, run the fan at low speed
2. DRY MODE
•
Press the MODE button to select Dry.
•
The temperature is controlled by the electronic card and cannot be regulated.
•
In this mode, each time the ON/OFF button is pressed, the unit switches off, the appliance saves the settings and
when switched back on again, it will retain them.
•
Fan speed is fixed to low and cannot be adjusted.
NOTE
The air conditioner does not cool the environment when operating as a dehumidifier.
When the appliance is used as a dehumidifier, the flexible hose must not be connected.
For maximum dehumidification efficiency, leave the rear discharge attachment free to discharge directly into
the environment.
Dehumidification mode is recommended in autumn and winter.
If used in the summer, it is best to leave the flexible hose attached, in order to send the hot air outside rather
than releasing it into the environment.
During dehumidification, it is best to provide for continuous drainage (see the next chapter, "HOW TO ELIMINATE
CONDENSATION").
3. FAN ONLY MODE
•
Press the MODE button until the Fan icon displays.
•
In this mode, the fan speed can be set.
•
The temperature cannot be regulated.
This equipment automatically evaporates condensation in Cooling and Heating mode.
When the air conditioner operates on Cool mode, there is no need to arrange for continuous drainage of
condensation; only in specific weather conditions where air humidity levels are very high may water deposit within
the unit. When the unit's tank is full, it beeps 8 times and the display reads "H8" to indicate that the tank is full; the air
conditioner switches off.
INSTALLING THE DRAIN HOSE
1. Remove the rubber plug on the back of the unit.
V 12/14
OPERATING MODES
HOW TO ELIMINATE CONDENSATION
2. Screw the clamp onto the back of the unit to the right of
the drain hole.
21