Cisco 2691 Series Manual del usuario - Página 43

Navegue en línea o descargue pdf Manual del usuario para Hardware de red Cisco 2691 Series. Cisco 2691 Series 48 páginas. Modular routers
También para Cisco 2691 Series: Instalación y formato (34 páginas), Ficha de datos (8 páginas), Manual de inicio rápido (29 páginas)

Imprimir página

Initial Setup

•

System Initialization and Configuration

•

Cisco 1721, 1760, 2621XM, 2651XM, 2691, 3725, and 3745 Modular Access Routers and 7206-VXR NPE-400 Router FIPS 140-2 Non-Proprietary

OL-6083-01

Secure Operation of the Cisco 1721, 1760, 2621XM, 2651XM, 2691, 3725, 3745, and 7206 VXR NPE-400 Routers

The Crypto Officer must apply tamper evidence labels as described in the

section of this document.

Only a Crypto Officer may add and remove WAN Interface Cards. When removing the tamper

evidence label, the Crypto Officer should remove the entire label from the router and clean the cover

of any grease, dirt, or oil with an alcohol-based cleaning pad. The Crypto Officer must re-apply

tamper evidence labels on the router as described in the

document.

The Crypto Officer must apply the opacity shield as described in the

Cryptographic Module"

of this document.

The Crypto Officer must perform the initial configuration. Cisco IOS version 12.3(3d) is the only

allowable image; no other image may be loaded.

For Cisco 1700, 2600, and 3700 series routers, the value of the boot field must be 0x0101. For Cisco

7200 series routers, the value of the boot field must be 0x0102. This setting disables break from the

console to the ROM monitor and automatically boots the Cisco IOS image. From the "configure

terminal" command line, the Crypto Officer enters the following syntax:

For Cisco 7200 series routers, enter:

–

config-register 0x0102

For Cisco 1700, 2600, and 3700 series routers, enter

–

config-register 0x0101

The Crypto Officer must create the "enable" password for the Crypto Officer role. The password

must be at least 8 characters and is entered when the Crypto Officer first engages the "enable"

command. The Crypto Officer enters the following syntax at the "#" prompt:

enable secret <PASSWORD>

The Crypto Officer must always assign passwords (of at least 8 characters) to users. Identification

and authentication on the console port is required for Users. From the "configure terminal"

command line, the Crypto Officer enters the following syntax:

line con 0

password <PASSWORD>

The Crypto Officer shall only assign users to a privilege level 1 (the default).

The Crypto Officer shall not assign a command to any privilege level other than its default.

The Crypto Officer may configure the module to use RADIUS or TACACS+ for authentication.

Configuring the module to use RADIUS or TACACS+ for authentication is optional. If the module

is configured to use RADIUS or TACACS+, the Crypto-Officer must define RADIUS or TACACS+

shared secret keys that are at least 8 characters long.

If the Crypto Officer loads any IOS image onto the router, this will put the router into a non-FIPS

mode of operation.

"Physical Security"

section of this

"The Cisco 1721/1760