Cisco 2800 Series Configuración de - Página 21

Navegue en línea o descargue pdf Configuración de para Hardware de red Cisco 2800 Series. Cisco 2800 Series 32 páginas. Cisco ios software configuration
También para Cisco 2800 Series: Manual de inicio rápido (13 páginas), Ficha de datos (8 páginas), Manual de inicio rápido (47 páginas), Nota de aplicación (41 páginas), Manual de inicio rápido (45 páginas), Configuración (10 páginas), Visión general (27 páginas), Ficha de datos (5 páginas), Ficha de datos (20 páginas)

Configuring Radio Settings on an Access Point

Configuring Beacon Period and DTIM on an Access Point

Perform this task to configure the beacon period and delivery traffic indication message (DTIM).

The beacon period is the amount of time between AP beacons in Kilo microseconds. One

kilomicrosecond equals 1,024 microseconds. The Data Beacon Rate, always a multiple of the beacon

period, determines how often the beacon contains a DTIM. The DTIM tells power-save client devices

that a packet is waiting for them.

For example, if the beacon period is set at 100, its default setting, and the data beacon rate is set at 2, its

default setting, then the AP sends a beacon containing a DTIM every 200 kilomicroseconds.

The default beacon period is 100, and the default DTIM is 2.

SUMMARY STEPS

enable

configure terminal

interface dot11Radio interface

beacon {period microseconds | dtim-period period-count}

end

copy running-config startup-config

How to Configure Radio Settings on an Access Point