Cisco 3800 Series Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Hardware de red Cisco 3800 Series. Cisco 3800 Series 7 páginas. Password recovery procedure
También para Cisco 3800 Series: Ficha de datos (8 páginas), Nota de aplicación (41 páginas), Manual de solución de problemas (15 páginas), Ficha de datos (20 páginas), Manual de inicio rápido (40 páginas), Configuración de (32 páginas)
Imprimir página
Router(config)#^Z
00:01:54: %SYS−5−CONFIG_I: Configured from console by console
Router#show ip interface brief
Interface
IP−Address
Ethernet0/0 10.200.40.37
Serial0/0
unassigned
BRI0/0
193.251.121.157
BRI0/0:1
unassigned
BRI0/0:2
unassigned
Ethernet0/1 unassigned
Serial0/1
unassigned
Loopback0
193.251.121.157
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#interface Ethernet0/0
Router(config−if)#no shutdown
Router(config−if)#
00:02:14: %LINK−3−UPDOWN: Interface Ethernet0/0, changed state to up
00:02:15: %LINEPROTO−5−UPDOWN: Line protocol on Interface Ethernet0/0,
changed state to up
Router(config−if)#interface BRI0/0
Router(config−if)#no shutdown
Router(config−if)#
00:02:26: %LINK−3−UPDOWN: Interface BRI0/0:1, changed state to down
00:02:26: %LINK−3−UPDOWN: Interface BRI0/0:2, changed state to down
00:02:26: %LINK−3−UPDOWN: Interface BRI0/0, changed state to up
00:02:115964116991: %ISDN−6−LAYER2UP: Layer 2 for Interface BR0/0,
TEI 68 changed to up
Router(config−if)#^Z
Router#
00:02:35: %SYS−5−CONFIG_I: Configured from console by console
Router#copy running−config startup−config
Destination filename [startup−config]?
Building configuration...
[OK]
Router#show version
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600−IS−M), Version 12.0(7)T, RELEASE SOFTWARE (fc2)
Copyright (c) 1986−1999 by cisco Systems, Inc.
Compiled Tue 07−Dec−99 02:21 by phanguye
Image text−base: 0x80008088, data−base: 0x80C524F8
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
Router uptime is 3 minutes
System returned to ROM by abort at PC 0x802D0B60
System image file is "flash:c2600−is−mz.120−7.T"
cisco 2611 (MPC860) processor (revision 0x202)
with 26624K/6144K bytes of memory.
Processor board ID JAB031202NK (3878188963)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
Basic Rate ISDN software, Version 1.1.
2 Ethernet/IEEE 802.3 interface(s)
2 Serial(sync/async) network interface(s)
1 ISDN Basic Rate interface(s)
32K bytes of non−volatile configuration memory.
8192K bytes of processor board System flash partition 1 (Read/Write)
8192K bytes of processor board System flash partition 2 (Read/Write)
Configuration register is 0x2142
Router#configure terminal
OK?
Method
Status
YES
TFTP
administratively down
YES
TFTP
administratively down
YES
unset
administratively down
YES
unset
administratively down
YES
unset
administratively down
YES
TFTP
administratively down
YES
TFTP
administratively down
YES
TFTP
up
Protocol
down
down
down
down
down
down
down
up